Lösungsansatz
RawSource supplies the base chemicals that go into these programs. We can help with product selection, grade matching, and sourcing from multiple origins for supply security.
Typical Treatment Workflow
1
Water & System Assessment
Characterize the water and the system — hardness, alkalinity, pH, TDS/conductivity, microbial load, and the metallurgy and temperatures of the equipment being protected.
2
Program & Chemistry Selection
Match coagulants, flocculants, scale and corrosion inhibitors, biocides, or pH adjusters to the water profile and discharge limits, factoring compatibility with any existing program.
3
Jar Testing & Dosing
Confirm coagulant and flocculant dose and feed point by jar test, set inhibitor and biocide treat rates, and size packaging (drums, totes, bulk) to consumption.
4
Monitoring & Control
Track residuals, turbidity, ORP, corrosion coupons, and effluent compliance, adjusting chemistry and dose as feedwater and load change.
Recommended Chemistries (4)
Caustic Soda (Sodium Hydroxide) Beads
CAS 1310-73-2
Säuren & Salze
Primäralkali zur pH-Erhöhung
1824 (SODIUM HYDROXIDE SOLUTION) · Class Sodium hydroxide sets and holds boiler-water alkalinity/pH in the protective range and supplies the OH- needed to form hydroxyapatite with phosphate
Schmelzpunkt:318 °C Siedepunkt:> 130 °C at 760 mmHg Dichte:1.5 at 20 °C
Schnellansicht
Alle Details
Monosodium Phosphate
CAS 7558-80-7
Spezialadditive
pH-Einstellung
Supplies orthophosphate that reacts with residual Ca2+ under boiler alkalinity to form soft calcium hydroxyapatite sludge instead of hard tube scale
Schmelzpunkt:Decomposes at 75 Dichte:2360 kg/cu m Solubility: 121 g/L
Schnellansicht
Alle Details
Sodium Tripolyphosphate (STPP)
CAS 7758-29-4
Säuren & Salze
Chelatisierung / Sequestrierung
Polyphosphate both sequesters hardness and reverts to orthophosphate at temperature, reinforcing the phosphate residual that precipitates calcium as removable sludge
Schmelzpunkt:622 °C Dichte:2.52 g/cm3 Solubility: Freely soluble in water. Insoluble in ethanol
Schnellansicht
Alle Details
Polyacrylic Acid Sodium (PAAS)
CAS 9003-04-7
Polymere & Harze
Konditionierung
Conditions the phosphate/calcium sludge into a fine, fluid suspension so it discharges cleanly with blowdown rather than caking on tubes
Schnellansicht
Alle Details