塗料・建設 / ソリューションファミリー

グリコールエーテル・含酸素溶剤

水系および溶剤系塗料の造膜を可能にする造膜助剤と共溶剤 — butyl glycol ether、diethylene glycol monoethyl ether、凍結融解対策用グリコール、低VOC品も選択可能。

概要

グリコールエーテル系溶剤は、水系塗料が乾燥時に連続した塗膜を形成できるようにする造膜助剤および共溶剤です。 A coalescent temporarily softens latex particles so they fuse below the binder's minimum film-formation temperature (MFFT), then diffuses out of the film. Ethylene glycol monobutyl ether (butyl glycol ether, CAS 111-76-2) is the standard coalescent for latex systems. Specify a coalescent when a paint must cure at low ambient temperature, and size the dose to the binder's MFFT rather than overdosing for insurance.

Here is the honest trade-off. A coalescent lowers MFFT and improves cold-weather film formation, but a slow-evaporating coalescent stays in the film and counts toward the coating's VOC. Where regulations cap VOC, formulators move to low-VOC or VOC-exempt co-solvents and lean harder on binder design instead of dosing more solvent. Diethylene glycol monoethyl ether (CAS 111-90-0) is a high-boiling co-solvent used to extend open time and flow. Confirm the VOC classification for your product type and jurisdiction before locking a grade.

Ethylene glycol (CAS 107-21-1) and propylene glycol (CAS 57-55-6) sit in the same toolbox as freeze-thaw stabilizers and co-solvents; propylene glycol is the lower-toxicity choice where a paint may see consumer handling. Diacetone alcohol (CAS 123-42-2) is a ketone-alcohol co-solvent for solvency and flow. None of these replaces the binder, so treat them as formulation aids that tune drying and stability, not as the property-defining ingredient.

主な用途
  • 水系(ラテックス)建築用・工業用塗料向けの造膜助剤
  • 溶剤系塗料、ラッカー、印刷インキ用の共溶剤
  • 低温で保管・輸送される水系塗料用の凍結融解安定剤
  • 水系の木工用・金属用塗料におけるカップリングおよびオープンタイム調整助剤
  • 規制対象となる建築用塗料向けの低VOC共溶剤パッケージ
よくあるご質問
RawSourceは塗料向けにどのようなグリコールエーテル溶剤を供給していますか?
RawSourceは、ラテックス用の標準的な造膜助剤であるエチレングリコールモノブチルエーテル、高沸点の併用溶剤であるジエチレングリコールモノエチルエーテル、凍結融解安定剤および併用溶剤として用いられるエチレングリコールとプロピレングリコールを調達します。ケトンアルコール系の併用溶剤であるジアセトンアルコールも供給可能です。いずれもご依頼に応じてCASと用途機能を明記のうえバルクでお見積りします。
造膜助剤は水系塗料でどのような働きをしますか?
造膜助剤は蒸発の遅い溶剤で、ラテックス粒子を一時的に軟化させ、バインダーの最低造膜温度 (MFFT) 以下でも連続した被膜に融合させます。その後、被膜の硬化に伴って拡散して抜けていきます。造膜助剤が不足すると、低温で塗装したラテックス塗料は割れたり、適切な被膜を形成できないことがあります。
グリコールエーテル系造膜助剤は塗料のVOCに加算されますか?
乾燥被膜中に残留する蒸発の遅い造膜助剤は、一般に塗料のVOCに算入されます。VOCが規制で上限設定されている場合、配合メーカーは低VOCまたはVOC適用除外の助溶剤を選び、バインダー設計への依存度を高めます。グレードを指定する前に、対象製品タイプおよび法域におけるVOCの分類と上限をご確認ください。
塗料におけるethylene glycolとpropylene glycolの違いは何ですか?
いずれも凍結融解安定剤および共溶剤として機能します。propylene glycol は一般に、消費者が扱う可能性のある塗料など、より低毒性が望まれる用途で選ばれ、ethylene glycol は工業用システムで使用されます。これらは安定性と乾燥性を調整する配合助剤であり、物性を決定づけるバインダーではありません。
免責事項。 Information on this page is provided for general reference and compiled from authoritative public sources (e.g. PubChem/ECHA). Values are typical and are not a guaranteed specification; the Certificate of Analysis (CoA) for the lot you purchase governs. Products are sold for industrial and professional use only. Nothing here is a medical, health, or efficacy claim. Always consult the current Safety Data Sheet (SDS) before handling, and confirm regulatory status, classification, and suitability for your application and jurisdiction.
見積り依頼 製品ページ

製品カタログ →